The production of water pipe gun is divided into which stages

The craft and practicality of the water bong is its biggest feature, its production process is very complicated, the pre-treatment, mid-term, and post-treatment have strict procedures, here we will understand which stages to go through to make the water bong.

Glass water bong pre-treatment section, glass bottle spraying pre-treatment section including pre-off, main off, table conditioning, etc. If it is in the north, the main off part of the temperature can not be too low, need insulation. Otherwise, the treatment effect is not ideal; glass bottle blowing ash purification section. If the process requirements of the sprayed workpiece is relatively high, this section is essential, glass water fume gun otherwise if the workpiece is adsorbed with a lot of dust, the surface of the workpiece after processing will have a lot of granular, so that the quality is reduced; glass water fume gun Powder spraying section. This section is the most critical is the technical problems of the spray powder master, to create excellent quality, spend money to hire a skilled master or a very good preheating section. Pre-treatment will enter the preheating section, generally need 8 to 10 minutes, the glass bottle is best when it reaches the powder room to make the sprayed workpiece has a certain amount of residual heat, in order to increase the adhesion of the powder foam.

Understand the steps of the production of water fume gun, you have a further understanding of the water fume gun? Do you still want to know more about the product? Such as maintenance and use tips, then enter our website to learn more knowledge.